After setting up replication, you can configure replication reports to be sent via email. This procedure can be run from the source or target system.
To set replication report options
| 1 | Log in to the source or target system. |
| 2 | Select the source system in the Navigation Pane, and then select > Replication > Replication Attributes. |
| 3 | In the Replication Report Options section, enter the following to receive email reports: |
| • | The email address in the Report Email Address field. |
| • | The time to receive the report in the Time to Send Report field. |
Note: If you want to receive an email Replication report, you must enter values in each of these fields.
| 4 | Click Confirm to save these settings. |